Composite Air Brake DOT Push In to Connect Fittings

Our Composite DOT fittings are up to 50% lighter than our Brass DOT fittings. Revolutionary in their design with a high-strength and lightweight composite material tough enough to meet DOT requirements.

Push to Connect Fittings are made with an inner nitrile O-Ring and elastic grab ring with radial claws. Simply push the tubing in for an instant seal. To release, push on the push-sleeve and the tubing easily slides out.

Three piece construction with eyelet and o-ring seal.
Pre-applied teflon based pipe sealant on all conical male pipes, saves assembly time as well as installation labor.
A double bite collect for greater holding power.
Used primarily in air brake and air accessory applications.
Our Fittings Meet the Requirements of D.O.T. FMVSS 571.106 Air Brake Performance Requirements; SAE J1131, J2494-1 & J2494-3 Air Brake Performance Requirements.

SPECIFICATIONS
Temperature Range: -40º F to 220º F
Threads: NPTF Standard
Recommended Tubing: J844 Air Brake Tubing.

Simply click on the picture of the fitting to see a table of prices and sizes available.
Scroll to top